Searching for just a few words should be enough to get started. If you need to make more complex queries, use the tips below to guide you.
Article type: Research Article
Authors: Chen, Yuan-Hoa | Chen, Yi-Langb; c; *
Affiliations: [a] Department of Business Administration, Lunghwa University of Science and Technology, Taiwan | [b] Department of Industrial Engineering and Management, Ming Chi University of Technology, New Taipei, Taiwan | [c] Department of Industrial Design, Chang Gung University, Taiwan
Correspondence: [*] Address for correspondence: Yi-Lang Chen, Ph.D., Professor, Department of Industrial Engineering & Management, Ming Chi University of Technology, 84 Gungjuan Rd., Taishan Dist., New Taipei, 24301, Taiwan. Tel.: +886 2 29089899/Ext.3103; Fax: +886 2 2908 5900; E-mail: ylchen@mail.mcut.edu.tw
Abstract: BACKGROUND:Hammering is a functional task in which the wrist generally follows a path of motion, however, previous studies paid relatively little attention to it. OBJECTIVE:The main objective of this study is to determine the optimal working height while using a straight-handled hammer to perform the hammering task. METHODS:Ten participants performed the hammering tasks on three different working heights (64, 80, and 96 cm) using three subjective hammering forces (light, medium, and heavy). RESULTS:The results revealed that there were linear increasing trends of shoulder abduction, which increased with the increased working height when hammering and the trunk flexion revealed a contrary result. However, the ulnar deviation and trunk lateral bending were insensitive to the working heights. The hammering forces merely resulted in trunk flexion and lateral bending and no posture differences at upper extremities. CONCLUSION:The trade-off between acceptable trunk flexion and shoulder abduction was considered to determine a reasonable effective working height (by measuring downward from worker’s elbow height) in the range from 25 cm to 35 cm with a mean 30 cm. This range will be valuable for hammering job design.
Keywords: Hand tool, hammering posture, hammering force, working height
DOI: 10.3233/WOR-182791
Journal: Work, vol. 61, no. 2, pp. 181-187, 2018
IOS Press, Inc.
6751 Tepper Drive
Clifton, VA 20124
USA
Tel: +1 703 830 6300
Fax: +1 703 830 2300
sales@iospress.com
For editorial issues, like the status of your submitted paper or proposals, write to editorial@iospress.nl
IOS Press
Nieuwe Hemweg 6B
1013 BG Amsterdam
The Netherlands
Tel: +31 20 688 3355
Fax: +31 20 687 0091
info@iospress.nl
For editorial issues, permissions, book requests, submissions and proceedings, contact the Amsterdam office info@iospress.nl
Inspirees International (China Office)
Ciyunsi Beili 207(CapitaLand), Bld 1, 7-901
100025, Beijing
China
Free service line: 400 661 8717
Fax: +86 10 8446 7947
china@iospress.cn
For editorial issues, like the status of your submitted paper or proposals, write to editorial@iospress.nl
如果您在出版方面需要帮助或有任何建, 件至: editorial@iospress.nl