Searching for just a few words should be enough to get started. If you need to make more complex queries, use the tips below to guide you.
Article type: Research Article
Authors: Holmbäck, Anna Mariaa | Lexell, Janb; c
Affiliations: [a] Department of Health Sciences, Division of Physical Therapy, Lund University, Lund, Sweden | [b] Department of Clinical Sciences, Division of Rehabilitation Medicine, Lund University, Lund, Sweden | [c] Department of Health Sciences, Luleå University of Technology, Luleå, Sweden
Note: [] Address for correspondence: Anna Maria Holmbäck, PhD, Lund University, University Hospital, Division of Physical Therapy, SE-220 05 Lund, Sweden. Tel.: +46 46 222 89 56; Fax: +46 46 22 42 02; E-mail: anna_maria.holmback@med.lu.se
Abstract: The aim of this study was to determine the test-retest (two occasions seven days part) reproducibility of isokinetic (Biodex) concentric (CON) and eccentric (ECC) ankle dorsiflexor strength and fatigue measurements in older subjects using several statistical methods. Thirty healthy men (n=15) and women (n=15) aged between 70 and 85 years participated in the study. To determine the reproducibility of strength measurements, the 30 individuals performed three maximal CON and ECC contractions at 30°/s and 90°/s. The intraclass correlation coefficient (ICC_{2.1}) for CON and ECC strength measurements was high and ranged from 0.94 to 0.98. Bland & Altman graphs and analyses indicted no systematic bias. The standard error of measurement (SEM), representing the smallest change that indicates a real improvement (or deterioration) for a group of individuals, was small (< 2.3 Nm). The smallest real difference (SRD), representing the smallest detectable change that indicates a real improvement (or deterioration) for a single subject, was also small ('error bands' from −7.2 Nm to 5.6 Nm). A high correlation (Pearson's r > 0.94) between CON peak torque at 30°/s and 90°/s, as well as ECC peak torque at 30°/s and 90°/s, suggested that any of these two velocities could be used as a reference. To determine the reproducibility of fatigue measurements, 28 of the 30 individuals performed 50 maximal CON contractions at 60°/s. Reproducibility of the loss in work (work fatigue) and the relative loss in peak torque, comparing the first three to the last three contractions (3-3), was determined and the ICC was 0.71 and 0.60, respectively. In addition, the SEM was small (< 8.4%) and the 'error bands' to define the SRD for a single subject were also small (from −23.5% to 24.5%). In conclusion, these values indicate small measurement errors and thus provide a clinically acceptable basis for testing ankle dorsiflexion strength and fatigue of the dominant side in healthy older people.
Keywords: Aging, ankle, muscle strength, muscle fatigue, reproducibility of results
DOI: 10.3233/IES-2007-0282
Journal: Isokinetics and Exercise Science, vol. 15, no. 4, pp. 263-270, 2007
IOS Press, Inc.
6751 Tepper Drive
Clifton, VA 20124
USA
Tel: +1 703 830 6300
Fax: +1 703 830 2300
sales@iospress.com
For editorial issues, like the status of your submitted paper or proposals, write to editorial@iospress.nl
IOS Press
Nieuwe Hemweg 6B
1013 BG Amsterdam
The Netherlands
Tel: +31 20 688 3355
Fax: +31 20 687 0091
info@iospress.nl
For editorial issues, permissions, book requests, submissions and proceedings, contact the Amsterdam office info@iospress.nl
Inspirees International (China Office)
Ciyunsi Beili 207(CapitaLand), Bld 1, 7-901
100025, Beijing
China
Free service line: 400 661 8717
Fax: +86 10 8446 7947
china@iospress.cn
For editorial issues, like the status of your submitted paper or proposals, write to editorial@iospress.nl
如果您在出版方面需要帮助或有任何建, 件至: editorial@iospress.nl