Affiliations: [a] General Dentist, King Abdulaziz Hospital, Ahsa, Saudi Arabia | [b] Department of Prosthetic Dental Sciences, College of Dentistry, King Saud University, Riyadh, Saudi Arabia
Correspondence:
[*]
Corresponding author: Syed Rashid Habib, Department of Prosthetic Dental Sciences, College of Dentistry, King Saud University, P.O. Box 60169, King Abdullah Road, Riyadh 11545, Saudi Arabia. Tel.: +966 1 467 7441/+966 534750834; Fax: +966 1 467 8548; E-mail: rashidhabib@hotmail.com.
Abstract: BACKGROUND: A well-made and properly cemented provisional restoration is essential for the health of abutment teeth and periodontium. Few focused studies are available on the effect of cementation techniques on the fit as well as on the retention of the provisional crowns. OBJECTIVE: To investigate the effect of six cement application techniques on the adaptation and retention of provisional crowns. METHODS: Seventy-two provisional crowns (Bisacryl resin) were fabricated over identical self-cured resin dies and were divided into six groups (N= 72; 6 ×n= 12) of cement application techniques (Temp Bond NE, Kerr Corporation). Group-A (Bulk Fill); Group-B (Cement on inner walls); Group-C (Cement on axial walls); Group-D (Cement on crown margin); Group-E (Cement on tooth margin); Group-F (Cement with vent-holes). Adaptation was assessed before and after cementation with digital caliper (0.001 mm). Universal testing machine was used for retention measurement in Mega Pascal’s (MPa). Data was analyzed by SPSS using Paired T-Test and Tukey’s test (p< 0.05). RESULTS: The highest and lowest difference between the two measurements was observed for the Group A (0.095 mm) and Group C (0.030 mm) respectively. Paired T-Test revealed significance (p< 0.05) between before and after cementation. Group-F (0.6094 MPa) and Group-E (0.1858 MPa) showed the highest and lowest retention respectively. Group-E (Cement on tooth margin) with lowest retention significantly differed (Tukey’s Test; p< 0.05) from other groups. CONCLUSIONS: Bulk filling of the provisional crown with luting cement significantly increases the adaptation discrepancies. Discrepancies are more when luting cement is applied on the occlusal surface of the crowns. However, it didn’t influence the retention of the crowns. Cement application on axial walls and cervical third of intaglio surface of crowns was the method of choice with regards to adaptation and retention combined. Addition of vent-holes improved the adaptation with best possible retention.
