Application of tuned vibration absorbers in fluid mounts

Article type: Research Article

Authors: Mashayekhi, Mohammad Jalali | Vahdati, Nader

Affiliations: School of Mechanical and Aerospace Engineering, Nanyang Technological University, 50 Nanyang Avenue, 639798, Singapore

Note: [] Corresponding author. Tel.: +65 6790 4332; Fax: +65 6791 1859; E-mail: mnader@ntu.edu.sg

Abstract: The need to reduce the fuel consumption of vehicles leads to having lighter chassis' with lighter engines yet maintaining engine power. These new design requirements are in contrast with the vibration isolation requirements. To keep the vehicles light yet provide good cabin noise and vibration isolation, requires a new vibration isolation technology. Fluid mounts have been used in the aerospace and the automotive industry to provide cabin noise and vibration reduction for years. With the use of passive fluid mounts, the highest cabin noise and vibration reduction is achieved at a frequency called "Notch Frequency". But typical passive fluid mounts have only one notch frequency. So the best cabin noise and vibration reduction is only achievable at one frequency. In this paper, a new fluid mount design in combination with a tuned vibration absorber is proposed. Bond graph modelling technique is used to model the new fluid mount design. The physical model and simulation results are presented. The effect of the natural frequency of the TVA on the dynamic stiffness of the fluid mount is studied.

Keywords: Fluid mount, tuned vibration absorber

DOI: 10.3233/SAV-2009-0489

Journal: Shock and Vibration, vol. 16, no. 6, pp. 565-580, 2009