Searching for just a few words should be enough to get started. If you need to make more complex queries, use the tips below to guide you.
Article type: Research Article
Authors: Omotayo, Azeeza; * | Elbakri, Idrisa; b; c
Affiliations: [a] Division of Medical Physics, CancerCare Manitoba, Winnipeg, MB, Canada | [b] Department of Radiology, University of Manitoba, Winnipeg, MB, Canada | [c] Department of Physics and Astronomy, University of Manitoba, Winnipeg, MB, Canada
Correspondence: [*] Corresponding author: Azeez Omotayo, Division of Medical Physics, CancerCare Manitoba, 675 McDermot Avenue, Winnipeg, MB R3E 0V9, Canada. Tel.: +1 204 787 8023; Fax: +1 204 775 1685; E-mail: aomotayo@cancecare.mb.ca.
Abstract: OBJECTIVE: Iterative algorithms are gaining clinical acceptance in CT. We performed objective phantom-based image quality evaluation of five commercial iterative reconstruction algorithms available on four different multi-detector CT (MDCT) scanners at different dose levels as well as the conventional filtered back-projection (FBP) reconstruction. METHODS: Using the Catphan500 phantom, we evaluated image noise, contrast-to-noise ratio (CNR), modulation transfer function (MTF) and noise-power spectrum (NPS). The algorithms were evaluated over a CTDIvol range of 0.75–18.7 mGy on four major MDCT scanners: GE DiscoveryCT750HD (algorithms: ASIR™ and VEO™); Siemens Somatom Definition AS+ (algorithm: SAFIRE™); Toshiba Aquilion64 (algorithm: AIDR3D™); and Philips Ingenuity iCT256 (algorithm: iDose4™). Images were reconstructed using FBP and the respective iterative algorithms on the four scanners. RESULTS: Use of iterative algorithms decreased image noise and increased CNR, relative to FBP. In the dose range of 1.3–1.5 mGy, noise reduction using iterative algorithms was in the range of 11%–51% on GE DiscoveryCT750HD, 10%–52% on Siemens Somatom Definition AS+, 49%–62% on Toshiba Aquilion64, and 13%–44% on Philips Ingenuity iCT256. The corresponding CNR increase was in the range 11%–105% on GE, 11%–106% on Siemens, 85%–145% on Toshiba and 13%–77% on Philips respectively. Most algorithms did not affect the MTF, except for VEO™ which produced an increase in the limiting resolution of up to 30%. A shift in the peak of the NPS curve towards lower frequencies and a decrease in NPS amplitude were obtained with all iterative algorithms. VEO™ required long reconstruction times, while all other algorithms produced reconstructions in real time. Compared to FBP, iterative algorithms reduced image noise and increased CNR. CONCLUSIONS: The iterative algorithms available on different scanners achieved different levels of noise reduction and CNR increase while spatial resolution improvements were obtained only with VEO™. This study is useful in that it provides performance assessment of the iterative algorithms available from several mainstream CT manufacturers.
Keywords: Computed tomography, image quality, reconstruction, spatial resolution, contrast, noise, iterative algorithms
DOI: 10.3233/XST-160601
Journal: Journal of X-Ray Science and Technology, vol. 24, no. 6, pp. 913-930, 2016
IOS Press, Inc.
6751 Tepper Drive
Clifton, VA 20124
USA
Tel: +1 703 830 6300
Fax: +1 703 830 2300
sales@iospress.com
For editorial issues, like the status of your submitted paper or proposals, write to editorial@iospress.nl
IOS Press
Nieuwe Hemweg 6B
1013 BG Amsterdam
The Netherlands
Tel: +31 20 688 3355
Fax: +31 20 687 0091
info@iospress.nl
For editorial issues, permissions, book requests, submissions and proceedings, contact the Amsterdam office info@iospress.nl
Inspirees International (China Office)
Ciyunsi Beili 207(CapitaLand), Bld 1, 7-901
100025, Beijing
China
Free service line: 400 661 8717
Fax: +86 10 8446 7947
china@iospress.cn
For editorial issues, like the status of your submitted paper or proposals, write to editorial@iospress.nl
如果您在出版方面需要帮助或有任何建, 件至: editorial@iospress.nl