Searching for just a few words should be enough to get started. If you need to make more complex queries, use the tips below to guide you.
Article type: Research Article
Authors: Iossifidou, Anna N.a | Baltzopoulos, Vassiliosa
Affiliations: [a] Department of Exercise and Sport Science, Crewe and Alsager Faculty, The Manchester Metropolitan University, Alsager, UK
Note: [] Corresponding author: Anna N. Iossifidou, Department of Exercise and Sport Science, Crewe and Alsager Faculty, The Manchester Metropolitan University, Alsager ST7 2HL, UK.
Abstract: Moment measurements in isokinetic dynamometry are influenced by moments due to acceleration. The purpose of the present study was to examine the inertial effects on peak moment, power and work during concentric isokinetic knee extension at 60, 180 and 300 deg/s. Seven healthy young adults participated in the present study. Angular displacement from the Biodex software was used to calculate angular velocity and acceleration. A recursive second-order Butterworth filter was applied on angular displacement data and a cut-off frequency of approximately 5 Hz was used based on power spectrum assessment. Finally the actual joint moment was calculated by taking into account the moments due to acceleration of the limb-lever arm system. In general the correlations between the examined parameters were not influenced by inertial effects. A weak relationship between peak moment and power was found at 300 deg/s. Furthermore the differences between dynamometer moment and the moment corrected for the inertial effects increased as the preselected angular velocity increased. At 300 deg s the dynamometer moment was 8.12% higher than the calculated joint moment. Absolute values of work measurements were similar before and after correction but work production was different during the initial acceleration and the final deceleration periods. Based on our findings it was concluded that corrections for inertial effects are essential during moment, work and power measurements at high velocities in isokinetic dynamometry. Finally, work and power should not be replaced by peak moment because they depend on both the range of motion and the moment development throughout the range of motion and therefore offer additional information concerning muscle and joint function.
Keywords: isokinetic, power, work, acceleration, moment
DOI: 10.3233/IES-1998-0022
Journal: Isokinetics and Exercise Science, vol. 7, no. 2, pp. 79-86, 1998
IOS Press, Inc.
6751 Tepper Drive
Clifton, VA 20124
USA
Tel: +1 703 830 6300
Fax: +1 703 830 2300
sales@iospress.com
For editorial issues, like the status of your submitted paper or proposals, write to editorial@iospress.nl
IOS Press
Nieuwe Hemweg 6B
1013 BG Amsterdam
The Netherlands
Tel: +31 20 688 3355
Fax: +31 20 687 0091
info@iospress.nl
For editorial issues, permissions, book requests, submissions and proceedings, contact the Amsterdam office info@iospress.nl
Inspirees International (China Office)
Ciyunsi Beili 207(CapitaLand), Bld 1, 7-901
100025, Beijing
China
Free service line: 400 661 8717
Fax: +86 10 8446 7947
china@iospress.cn
For editorial issues, like the status of your submitted paper or proposals, write to editorial@iospress.nl
如果您在出版方面需要帮助或有任何建, 件至: editorial@iospress.nl