Estimation of endothelial shear stress in atherosclerotic lesions detected by intravascular ultrasound using computational fluid dynamics from coronary CT scans with a pulsatile blood flow and an individualized blood viscosity
Affiliations: [a] Department of Radiology, University Hospital, LMU Munich, Munich, Germany
| [b] Department of Cardiology, Privatklinik Dr. Robert Schindlbeck, Herrsching am Ammersee, Germany
| [c] Department of Medicine I, University Hospital, LMU Munich, Munich, Germany
Correspondence:
[*]
Corresponding author: Adrian Curta MD, Department of Radiology, University Hospital, LMU Munich, Marchioninistr. 15, 81377 Munich, Germany. Tel.: +49 89 4400 73620; Fax: +49 89 4400 7883; E-mail: adrian.curta@med.uni-muenchen.de.
Abstract: INTRODUCTION: Endothelial shear stress (ESS) is a local hemodynamic factor that is dependent on vessel geometry and influences the process of atherogenesis. As in vivo measurements of ESS are not possible, it must be calculated using computational fluid dynamics (CFD). In this feasibility study we explore CFD-models generated from coronary CT-angiography (CCTA) using an individualised blood viscosity and a pulsatile flow profile derived from in vivo measurements. MATERIALS AND METHODS:We retrospectively recruited 25 consecutive patients who received a CCTA followed by a coronary angiography including intravascular ultrasound (IVUS) and generated 3D models of the coronary arteries from the CT-datasets. We then performed CFD-simulations on these models. Hemodynamically non-relevant stenosis were identified in IVUS. They were isolated in the CFD-model and separated longitudinally into a half with atherosclerotic lesion (AL) and one without (NAL). ESS was measured and compared for both halves. RESULTS:After excluding vessels with no IVUS data or relevant stenosis we isolated 31 hemodynamically non-relevant excentric AL from a total of 14 vessels. AL segments showed consistently significantly lower ESS when compared to their corresponding NAL segments when regarding minimum (0.9 Pa, CI [0.6, 1.2] vs. 1.3 Pa, CI [0.9, 1.8]; p = 0.004), mean (5.0 Pa, CI [3.4, 6.0] vs. 6.7 Pa, CI [5.5, 8.4]; p = 0.008) and maximum ESS values (12.4 Pa, CI [8.6, 14.6] vs. 19.6 Pa, CI [12.4, 21.0]; p = 0.005). Qualitatively ESS was lower on the inside of bifurcations and curvatures. CONCLUSION:CFD simulations of coronary arteries from CCTA with an individualised flow profile and blood viscosity are feasible and could provide further prognostic information and a better risk stratification in coronary artery disease. Further prospective studies are needed to investigate this claim.
