Searching for just a few words should be enough to get started. If you need to make more complex queries, use the tips below to guide you.
Article type: Research Article
Authors: Nowak, Andrzej S. | Rakoczy, Przemyslaw | Sheikh Ibrahim, Firas I.
Affiliations: Department of Civil Engineering, University of Nebraska, Lincoln, NE, USA | Turner-Fairbank Highway Research Center, Federal Highway Administration, McLean, VA, USA
Note: [] Corresponding author. E-mail: anowak2@unl.edu
Abstract: The combination of dead load and live load is very important in design of bridge superstructure as, in practice, it controls the strength limit states. The basic set of load factors for the Strength I limit state is 1.25 for dead load and 1.75 for live load and dynamic load. For design cases when the dead load dominates, i.e. for Strength IV limit state, the dead load factor is 1.5. The acceptability criterion for load and resistance factors in the AASHTO LRFD Code is closeness to the target reliability index, which is assumed to be 3.5 for steel and concrete girder bridges. However, the reliability analysis performed for a full range of dead load to live load ratios indicates that when live load is about 10–20% of the total load, the reliability indices are about 3.0 which is lower than the target value of 3.5. This is an indication that the reliability level is insufficient and there is a need for increasing load factors. On the other hand, for dead load constituting about 100% of the total load (i.e. no live load), the reliability index is much higher than 3.5, which means that the load factor 1.5 can be reduced. Therefore, it is proposed to change the current Strength IV load factors to dead load of 1.4 and live load factor 1.4. The result is a more uniform reliability level for all combinations of dead load and live load. The results of reliability analysis are presented in graphs.
Keywords: Dead load, live load, dead-to-live load ratio, load combination, load factors
DOI: 10.3233/BRS-2012-0038
Journal: Bridge Structures, vol. 8, no. 2, pp. 61-66, 2012
IOS Press, Inc.
6751 Tepper Drive
Clifton, VA 20124
USA
Tel: +1 703 830 6300
Fax: +1 703 830 2300
sales@iospress.com
For editorial issues, like the status of your submitted paper or proposals, write to editorial@iospress.nl
IOS Press
Nieuwe Hemweg 6B
1013 BG Amsterdam
The Netherlands
Tel: +31 20 688 3355
Fax: +31 20 687 0091
info@iospress.nl
For editorial issues, permissions, book requests, submissions and proceedings, contact the Amsterdam office info@iospress.nl
Inspirees International (China Office)
Ciyunsi Beili 207(CapitaLand), Bld 1, 7-901
100025, Beijing
China
Free service line: 400 661 8717
Fax: +86 10 8446 7947
china@iospress.cn
For editorial issues, like the status of your submitted paper or proposals, write to editorial@iospress.nl
如果您在出版方面需要帮助或有任何建, 件至: editorial@iospress.nl