Affiliations: [a] Department of Mechanical Engineering, University of British Columbia, Vancouver, BC, Canada | [b] Department of Chemical and Biological Engineering, University of British Columbia, Vancouver, BC, Canada | [c] Biomedical Engineering Program, University of British Columbia, Vancouver, BC, Canada
Correspondence:
[*]
Address for correspondence: Dr. Dana Grecov, Department of Mechanical Engineering, University of British Columbia, Vancouver, BC, Canada. Tel.: +1 604 822-6710; Fax: +1 604 822-2403; E-mail: dgrecov@mech.ubc.ca.
Abstract: Background:Osteoarthritis is a common, localized joint disease that causes pain, stiffness and reduced mobility. Osteoarthritis is particularly common in the knees. The effects of osteoarthritis on the rheology of synovial fluid in the knees are not fully understood and consequently require further study. Objective:The purpose of this study is to investigate the effects of protein content on synovial fluid shear rheology. A secondary study outcome will include study of the temperature dependence of synovial fluid behaviour. Methods:38 osteoarthritic synovial fluid samples were studied under shear flow. Shear properties were correlated with protein concentration. Viscosupplement was used as a comparison and to verify measurement reliability. The effects of temperature were investigated at 20, 29 and 37°C. Results:Shear rheological properties were found to vary widely between samples, however all samples demonstrated clear non-Newtonian shear thinning behaviour. In general viscoelastic properties were lower in osteoarthritic samples than previously studied healthy synovial fluid. A moderate correlation was observed between synovial fluid dynamic moduli at a frequency of 2.5 Hz and protein concentration. Temperature was found to affect the rheology of osteoarthritic synovial fluid and was fitted with the Arrhenius model. Conclusions:Increased protein concentration has been correlated with decreased shear rheological parameters. Temperature dependence of synovial fluid was also demonstrated and modelled for use in Part 2 of this article.
