Deformation and rupture of Dunaliella salina at high shear rates without the use of thickeners

Article type: Research Article

Authors: Kokkinos, Dimitrios^a | Dakhil, Haider^{b; c} | Wierschem, Andreas^b | Briesen, Heiko^a | Braun, André^{a; *}

Affiliations: [a] Wissenschaftszentrum Weihenstephan für Ernährung und Landnutzung, Lehrstuhl für Systemverfahrenstechnik, Technical University of Munich (TUM), Freising, Germany | [b] Institute of Fluid Mechanics, Friedrich-Alexander-Universität Erlangen-Nürnberg (FAU), Erlangen, Germany | [c] Faculty of Engineering, University of Kufa, Kufa, Najaf, Iraq

Correspondence: [*] Address for correspondence: André Braun, Chair for Process Systems Engineering, Technical University of Munich, Gregor-Mendel-Str. 4, Freising, 85354, Germany. Tel.: +49 8161 71 3587; Fax: +49 8161 71 4510; E-mail: andre.braun@tum.de.

Abstract: Background:High-density cultures require operating below the critical threshold of shear stress, in order to avoid reducing the specific growth rate of the cells. When determining this threshold, direct inspection of the cells in flow provides insight into the conditions of shearing. Objective:Aim of this study was using a novel rheo-optical setup for the observation of cells in laminar shear flow and the determination of the critical shear stress required to damage them in their natural environment. Methods:Dunaliella salina cells were sheared and observed in flow for shear stresses of up to 90 Pa, at ambient temperature, without adding thickeners. The critical shear stress was determined by fitting a hydrodynamics-based criterion to the experimental data on the percentage of deformed cells after shearing. Results:Single cells, clusters and strings of cells were visible in shear flow. The strings formed at maximum shear stresses of 10 Pa or higher. Cells lost motility for maximum shear stresses higher than 15 Pa, and more than 80% of the cells were deformed at maximum shear stresses higher than 60 Pa. The estimated critical shear stress was 18 Pa. Conclusions:Shear stresses higher than 18 Pa should be avoided when cultivating D. salina.

Keywords: Microalgae, high shear stress, rheo-optics, narrow-gap geometry, parallel-plate configuration

DOI: 10.3233/BIR-15057

Journal: Biorheology, vol. 53, no. 1, pp. 1-11, 2016