Affiliations: Department of Fixed Prosthodontics, School of Dental Medicine, Tsurumi University, Yokohama, Japan | Department of Mechanical Engineering, Faculty of Engineering, Tokyo City University, Tokyo, Japan | Department of Maxillofacial Rehabilitation, Kanagawa Dental College, Kanagawa, Japan
Note: [] Address for correspondence: Yoshiharu Nakamura, Department of Fixed Prosthodontics, School of Dental Medicine, Tsurumi University, 2-1-3 Tsurumi, Tsurumi-ku, Yokohama 230-8501, Japan. Tel.: +81 45 581 1001; Fax: +81 45 573 9599; E-mail: nakamura-y@tsurumi-u.ac.jp.
Abstract: Polycrystalline diamond (PCD) exhibits excellent abrasive characteristics and is commonly used as loose grains for precision machining of hard ceramics and other materials that are difficult to grind and polish. In the present study, we investigated using bonded PCD for polishing dental porcelain, for which a lustrous surface is difficult to obtain by polishing. We compared the surface texture and characteristics of dental porcelain after polishing with bonded PCD with that obtained using bonded monocrystalline diamond (MCD), which is commonly used for this purpose. Polishing was performed at various pressures and rotational speeds on a custom-built polishing apparatus using bonded PCD or MCD with grain sizes of 3.92 μm on specimens consisting of VITA Omega 900 dentin porcelain after firing and then glazing to a specified surface roughness. The surface roughness of the polished porcelain and the abrasion quantity in terms of its polishing depth were measured, and its surface texture and characteristics were investigated. At low polishing pressures, PCD yielded a finer polished surface than MCD. The polishing depth after polishing for 20–30 min was approximately 2–3 μm with PCD and 1–2 μm with MCD. The polished surface was more uniform and smooth with PCD than with MCD.
